add tinyusb

tinyusb/hw/bsp/frdm_k32l2b/board.mk

@@ -0,0 +1,51 @@
+SDK_DIR = hw/mcu/nxp/mcux-sdk
+DEPS_SUBMODULES += $(SDK_DIR)
+
+CFLAGS += \
+  -mthumb \
+  -mabi=aapcs \
+  -mcpu=cortex-m0plus \
+  -DCPU_K32L2B31VLH0A \
+  -DCFG_TUSB_MCU=OPT_MCU_K32L2BXX
+
+# mcu driver cause following warnings
+CFLAGS += -Wno-error=unused-parameter
+
+MCU_DIR = $(SDK_DIR)/devices/K32L2B31A
+
+# All source paths should be relative to the top level.
+LD_FILE = $(MCU_DIR)/gcc/K32L2B31xxxxA_flash.ld
+
+SRC_C += \
+	src/portable/nxp/khci/dcd_khci.c \
+	$(MCU_DIR)/system_K32L2B31A.c \
+	$(MCU_DIR)/project_template/clock_config.c \
+	$(MCU_DIR)/drivers/fsl_clock.c \
+	$(SDK_DIR)/drivers/gpio/fsl_gpio.c \
+	$(SDK_DIR)/drivers/lpuart/fsl_lpuart.c
+
+INC += \
+	$(TOP)/hw/bsp/$(BOARD) \
+	$(TOP)/$(SDK_DIR)/CMSIS/Include \
+	$(TOP)/$(SDK_DIR)/drivers/smc \
+	$(TOP)/$(SDK_DIR)/drivers/common \
+	$(TOP)/$(SDK_DIR)/drivers/gpio \
+	$(TOP)/$(SDK_DIR)/drivers/port \
+	$(TOP)/$(SDK_DIR)/drivers/lpuart \
+	$(TOP)/$(MCU_DIR) \
+	$(TOP)/$(MCU_DIR)/drivers \
+	$(TOP)/$(MCU_DIR)/project_template \
+
+SRC_S += $(MCU_DIR)/gcc/startup_K32L2B31A.S
+
+# For freeRTOS port source
+FREERTOS_PORT = ARM_CM0
+
+# For flash-jlink target
+JLINK_DEVICE = MKL25Z128xxx4
+
+# For flash-pyocd target
+PYOCD_TARGET = K32L2B
+
+# flash using pyocd
+flash: flash-pyocd