add tinyusb

tinyusb/hw/bsp/lpc55/family.mk

@@ -0,0 +1,67 @@
+UF2_FAMILY_ID = 0x2abc77ec
+SDK_DIR = hw/mcu/nxp/mcux-sdk
+DEPS_SUBMODULES += lib/sct_neopixel $(SDK_DIR)
+
+include $(TOP)/$(BOARD_PATH)/board.mk
+
+# Default to Highspeed PORT1
+PORT ?= 1
+
+CFLAGS += \
+  -flto \
+  -mthumb \
+  -mabi=aapcs \
+  -mcpu=cortex-m33 \
+  -mfloat-abi=hard \
+  -mfpu=fpv5-sp-d16 \
+  -DCFG_TUSB_MCU=OPT_MCU_LPC55XX \
+  -DCFG_TUSB_MEM_ALIGN='__attribute__((aligned(64)))' \
+  -DBOARD_DEVICE_RHPORT_NUM=$(PORT)
+
+ifeq ($(PORT), 1)
+  $(info "PORT1 High Speed")
+  CFLAGS += -DBOARD_DEVICE_RHPORT_SPEED=OPT_MODE_HIGH_SPEED
+
+  # LPC55 Highspeed Port1 can only write to USB_SRAM region
+  CFLAGS += -DCFG_TUSB_MEM_SECTION='__attribute__((section("m_usb_global")))'
+else
+  $(info "PORT0 Full Speed")
+endif
+
+# mcu driver cause following warnings
+CFLAGS += -Wno-error=unused-parameter -Wno-error=float-equal
+
+MCU_DIR = $(SDK_DIR)/devices/$(MCU_VARIANT)
+
+# All source paths should be relative to the top level.
+LD_FILE ?= $(MCU_DIR)/gcc/$(MCU_CORE)_flash.ld
+
+SRC_C += \
+	src/portable/nxp/lpc_ip3511/dcd_lpc_ip3511.c \
+	$(MCU_DIR)/system_$(MCU_CORE).c \
+	$(MCU_DIR)/drivers/fsl_clock.c \
+	$(MCU_DIR)/drivers/fsl_power.c \
+	$(MCU_DIR)/drivers/fsl_reset.c \
+	$(SDK_DIR)/drivers/lpc_gpio/fsl_gpio.c \
+	$(SDK_DIR)/drivers/flexcomm/fsl_flexcomm.c \
+	$(SDK_DIR)/drivers/flexcomm/fsl_usart.c \
+	lib/sct_neopixel/sct_neopixel.c
+
+INC += \
+	$(TOP)/$(BOARD_PATH) \
+	$(TOP)/lib/sct_neopixel \
+	$(TOP)/$(MCU_DIR)/../../CMSIS/Include \
+	$(TOP)/$(MCU_DIR) \
+	$(TOP)/$(MCU_DIR)/drivers \
+	$(TOP)/$(SDK_DIR)/drivers/common \
+	$(TOP)/$(SDK_DIR)/drivers/flexcomm \
+	$(TOP)/$(SDK_DIR)/drivers/lpc_iocon \
+	$(TOP)/$(SDK_DIR)/drivers/lpc_gpio \
+	$(TOP)/$(SDK_DIR)/drivers/sctimer
+
+SRC_S += $(MCU_DIR)/gcc/startup_$(MCU_CORE).S
+
+LIBS += $(TOP)/$(MCU_DIR)/gcc/libpower_hardabi.a
+
+# For freeRTOS port source
+FREERTOS_PORT = ARM_CM33_NTZ/non_secure