getting the sensor watch dev board working

watch-library/config/hpl_eic_config.h

@@ -271,7 +271,7 @@
 // <i> Indicates whether the external interrupt 5 filter is enabled or not
 // <id> eic_arch_filten5
 #ifndef CONF_EIC_FILTEN5
-#define CONF_EIC_FILTEN5 0
+#define CONF_EIC_FILTEN5 1
 #endif
 
 // <q> External Interrupt 5 Event Output Enable
@@ -723,7 +723,12 @@
 
 // </e>
 
+// my god this is a hack. need to refactor this out of ASF and into our driver. - joey 10/19
+#ifdef CRYSTALLESS
+#define CONFIG_EIC_EXTINT_MAP {2, PIN_PA02}, {5, PIN_PB05}, {7, PIN_PA07},
+#else
 #define CONFIG_EIC_EXTINT_MAP {2, PIN_PA02}, {6, PIN_PA22}, {7, PIN_PA23},
+#endif
 
 // <<< end of configuration section >>>
 

watch-library/config/hpl_gclk_config.h

@@ -248,9 +248,14 @@
 // <i> This defines the clock source for generic clock generator 3
 // <id> gclk_gen_3_oscillator
 #ifndef CONF_GCLK_GEN_3_SOURCE
+#ifdef CRYSTALLESS
+#define CONF_GCLK_GEN_3_SOURCE GCLK_GENCTRL_SRC_OSCULP32K
+#else
 #define CONF_GCLK_GEN_3_SOURCE GCLK_GENCTRL_SRC_XOSC32K
 #endif
 
+#endif
+
 // <q> Run in Standby
 // <i> Indicates whether Run in Standby is enabled or not
 // <id> gclk_arch_gen_3_runstdby

watch-library/config/hpl_osc32kctrl_config.h

@@ -17,8 +17,12 @@
 // <i> This defines the clock source for RTC
 // <id> rtc_source_oscillator
 #ifndef CONF_RTCCTRL_SRC
+#ifdef CRYSTALLESS
+#define CONF_RTCCTRL_SRC GCLK_GENCTRL_SRC_OSCULP32K
+#else
 #define CONF_RTCCTRL_SRC GCLK_GENCTRL_SRC_XOSC32K
 #endif
+#endif
 
 // <q> Use 1 kHz output
 // <id> rtc_1khz_selection